Link Two Cisco Switch Stack’s via LCAP

Switch-A(config)#interface port-channel 1
Switch-A(config-if)#switchport trunk encapsulation dot1q
Switch-A(config-if)#switchport mode trunk
Switch-A(config-if)#speed nonegotiate

Switch-A(config)#interface GigabitEthernet1/1/1
Switch-A(config-if)#switchport mode trunk
Switch-A(config-if)#speed nonegotiate
Switch-A(config-if)#channel-group 1 mode active

Switch-A(config)#interface GigabitEthernet2/1/1
Switch-A(config-if)#switchport mode trunk
Switch-A(config-if)#speed nonegotiate
Switch-A(config-if)#channel-group 1 mode active
——————————————————-

Switch-B(config)#interface port-channel 1
Switch-B(config-if)#switchport trunk encapsulation dot1q
Switch-B(config-if)#switchport mode trunk
Switch-B(config-if)#speed nonegotiate

Switch-B(config)#interface GigabitEthernet1/1/1
Switch-B(config-if)#switchport mode trunk
Switch-B(config-if)#speed nonegotiate
Switch-B(config-if)#channel-group 1 mode active

Switch-B(config)#interface GigabitEthernet2/1/1
Switch-B(config-if)#switchport mode trunk
Switch-B(config-if)#speed nonegotiate
Switch-B(config-if)#channel-group 1 mode active

VN:F [1.9.22_1171]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.22_1171]
Rating: 0 (from 0 votes)

Tags: Cisco, LCAP, link, portchannel, stack, trunk

Trackback from your site.